Toshiba E-STUDIO2006 - Page 66

e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A © 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 24
[ 4 ] Bypass feed copying
1. Insert a sheet of paper into the bypass tray.
Bypass paper sensor ON
- Bypass feed priority state.
2. Press the [START] button
“READY”  “COPYING”
CIS LED ON
Scan motor ON  CIS unit move forward
Polygonal motor rotates
Main motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3. Bypass feeding
Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
Bypass feed clutch
- The bypass feed roller start to rotate.
Paper reaches the registration roller
Aligning operation
After a certain period of time, the bypass feed clutch OFF
4. Hereafter, the operation 3) through 6) of  P. 3-23 "[ 3 ] Drawer feed copying (1st drawer paper
feeding)" is repeated.