© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 197
2
Note: Note:
In this equipment, a toner image is formed on the transfer belt prior to a paper feeding.
When the feeding retry occurs and the transport timing is delayed, the toner image on the trans-
fer belt is cleaned off without the 2nd transfer since the paper cannnot be reached for the 2nd
transfer proccess.
After that, the toner image fomation is retried while the paper is waited.
In this case, the toner for this image formation is consumed wastefully since the toner image on
the transfer belt is already cleaned off, even though the printing is normally completed.
Therefore, note that the excessive toner will be consumed consequently when the upper limit
value of feeding retry counter is set larger or set as "0" (no limit).
The toner is also consumed wastefully when the paper misfeeding occurs. Replace the roller at
earlier timing if the paper misfeedings have occurred frequently.
9889 General Acceptance of data cloning
using USB storage device
ALL 0
<0-1>
SYS Acceptance of the
usage of the USB data
cloning tool
0: Accepted
1: Not accepted
2
9891 User
interface
Warning message on the
touch panel when PM
(Periodic Maintenance)
time has come
ALL 1
<0-1>
SYS 0: No warning notifica-
tion
1: Warning notification
1
9946 General E-mail transmission retry
number
ALL 3
<0-14>
SYS The number of times of
E-mail communication
retry for Scan to E-mail
and Internet Fax is set.
1
9947 General E-mail transmission retry
interval
ALL 1
<0-15>
SYS When E-mail transmis-
sion retry for Scan to E-
mail and Internet Fax is
performed, the interval
is set.
0 min - 15 min
1
Setting mode (08)
Code
Classifi-
cation
Items
Func-
tion
Default
<Accept-
able
value>
RAM Contents
Pro-
cedur
e
To Next Page
Loading...
