e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 6
EA40 Finisher jam
(Finisher section)
Door open jam:
1) The finisher has been released from the equip-
ment during printing. [MJ-1022]
2) The upper/front cover of the finisher section or
the upper/ front door of the puncher section has
opened during printing. [MJ-1023/1024]
3) The front cover or stationary tray cover is
opened during paper transport. [MJ-1101]
P. 5 - 3 6
EA50 Stapling jam: Stapling is not performed properly.
[MJ-1022/1023/1024/1101]
P. 5 - 3 8
EA60 Early arrival jam: The inlet sensor detects the paper
earlier than a specified timing. [MJ-1022/1023/
1024/1101]
P. 5 - 4 0
EA70 Stack delivery jam: It cannot deliver the stack of
paper on the intermediary process tray to the stack
tray. [MJ-1022]
P. 5 - 4 1
Stack exit belt home position error: The stack exit
belt is not at the home position. [MJ-1101]
EA80 Finisher jam
(Saddle stitcher sec-
tion)
Stapling jam: Stapling is not performed properly.
[MJ-1024]
P. 5 - 4 3
EA90 Door open jam: The delivery cover or inlet cover
has opened dur-ing printing [MJ-1024].
P. 5 - 4 3
EAA0 Power-ON jam: Paper exists at No.1 paper sensor,
No. 2 paper sensor, No.3 paper sensor, vertical
path paper sensor or delivery sensor when power is
turned ON. [MJ-1024]
P. 5 - 4 4
EAB0 Transport stop jam: The paper which passed
through the inlet sensor does not reach or pass
No.1 paper sensor, No. 2 paper sensor, No.3 paper
sensor or delivery sensor. [MJ-1024]
P. 5 - 4 4
EAC0 Transport delay jam: The paper which has reached
the inlet sensor does not pass through the inlet sen-
sor. [MJ-1024]
P. 5 - 4 5
EAD0 Other paper jam Print end command time-out jam: The printing has
not finished normally because of the communica-
tion error between the SYS board and LGC board
at the end of printing.
P. 5 - 4 7
EAE0 Finisher jam Receiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the fin-
isher.
P. 5 - 4 7
EAF0 Finisher jam
(Finisher section)
Stack return jam: It cannot load the paper which
passed through the delivery roller on the intermedi-
ary process tray. [MJ-1022]
P. 5 - 4 2
EB30 Finisher jam Ready time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
P. 5 - 4 7
EB50 Paper transport jam Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
P. 5 - 1 6
EB60 Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
P. 5 - 1 7
Error code Classification Contents Troubleshooting
07/11
To Next Page
Loading...
