© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO281c/351c/451c
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 7
2
ED10 Finisher jam Skew adjustment motor (M1) home position detec-
tion abnormality: The Skew adjustment motor is not
at the home position. [MJ-1101 (when MJ-6101 is
installed)]
P. 5 - 4 8
ED11 Sideways adjustment motor (M2) home position
detection error: The Sideways adjustment motor is
not at the home position. [MJ-1101 (when MJ-6101
is installed)]
P. 5 - 4 8
ED12 Shutter home position error: The shutter is not at
the home position. [MJ-1101]
P. 5 - 4 9
ED13 Front alignment plate home position error: The front
alignment plate is not at the home position. [MJ-
1101]
P. 5 - 4 9
ED14 Rear alignment plate home position error: The rear
alignment plate is not at the home position. [MJ-
1101]
P. 5 - 5 0
ED15 Paddle home position error: The paddle is not at the
home position. [MJ-1101]
P. 5 - 5 0
ED16 Buffer tray home position error: The buffer tray is
not at the home position. [MJ-1101]
P. 5 - 5 1
Error code Classification Contents Troubleshooting
To Next Page
Loading...
