OPERATOR’S MANUAL
series Robot Controller
4.4.9 Aborting and Quitting Edit [NOSAVE]..................................... 4-33
4.5 Automatic Start File.............................................................................. 4-34
Section 5 Data Editing.................................................................................... 5-1
5.1 Starting Up the Data Editor.................................................................. 5-1
5.2 Positional Data Directory Display Mode............................................... 5-3
5.2.1 Editing of Positional Data Name............................................. 5-7
5.2.2 Editing of Position Element..................................................... 5-10
5.2.3 Addition of New Positional Data (INS).................................... 5-13
5.2.4 Deletion of Positional Data (ALT + BS) .................................. 5-15
5.2.5 Quitting Data Editing [SAVE].................................................. 5-16
5.2.6 Abortion and Quitting Data Editing [NOSAVE] ....................... 5-18
5.2.7 Return to Program Editor [PRG]............................................. 5-20
5.2.8 Call of Detailed Positional Data Display [FULL]...................... 5-21
5.2.9 Call of Coordinate Data Directory Display [TRANS] ............... 5-22
5.2.10 Call of Load Data Directory Display [PYLD] ........................... 5-23
5.2.11 Search of Positional Data [FIND]............................................ 5-24
5.2.12 Teach of Positional Data [TEACH] ......................................... 5-27
5.2.13 Move to Teach Point [M–TO].................................................. 5-29
5.2.14 Cut of Positional Data [CUT] .................................................. 5-31
5.2.15 Paste of Positional Data [PASTE]........................................... 5-34
6.2.16 Move to Teach Point [BYPAS]................................................ 5-35
5.3 Detailed Positional Data Display Mode................................................ 5-39
5.3.1 Editing of Detailed Positional Data Name............................... 5-42
5.3.2 Editing of Detailed Position Data Element.............................. 5-45
5.3.3 Call of Positional Data Directory Display [DIR]....................... 5-48
5.4 Coordinate Data Directory Display Mode............................................. 5-49
5.4.1 Addition of New Coordinate Data (INS).................................. 5-52
5.4.2 Deletion of Coordinate Data (ALT + BS) ................................ 5-54
5.4.3 Call of Detailed Coordinate Data Display ............................... 5-55
5.4.4 Call of Load Data Directory Display [PYLD] ........................... 5-56
5.4.5 Setting of Work Coordinate System
(Call of Positional Data Directory Display) [WORK]................ 5-57
5.4.6 Setting and Cancel of Tool Coordinate System [TOOL] ......... 5-58
5.4.7 Search of Coordinate Data [FIND].......................................... 5-59
5.4.8 Cut of Coordinate Data [CUT] ................................................ 5-62
5.4.9 Paste of Coordinate Data [PASTE]......................................... 5-65
5.5 Detailed Coordinate Data Display Mode.............................................. 5-66
STE 80720
– j –
To Next Page
Loading...
Need help?
General
