Toshiba TS3000 Series - Copying [COPY]

OPERATOR’S MANUAL
series Robot Controller
4.4.4 Copying [COPY]
(1) Function
Saves a specified range of blocks in the buffer.
(2) Procedures
(a) Step 1: Designation of start block position.
Designating the start block of a range to be copied.
Move the cursor to the first character of a desired start block.
P R G R A M . N A M C : 1 L : 2
P R O G R A M T E S T
S P E E D = 5 0
M O V E A
M O V E B
M O V E C
N O S A V C O P Y C U T P A S T E >
(b) Step 2: Execution of copy command.
Press [COPY] to execute the copy command.
P R G R A M . N A M C : 1 L : 2
P R O G R A M T E S T
S P E E D = 5 0
M O V E A
M O V E B
M O V E C
C O P Y R A N G >
N O S A V C O P Y C U T P A S T E >
(c) Step 3: Designation of end position.
Move the cursor so that the final character of the specified range is indicated
by the reversed image. The specified range of blocks is inversely displayed
and you can copy the blocks under this condition.
STE 80720
– 4-22 –