OPERATOR’S MANUAL
series Robot Controller
6.6 Startup [RUN]
(1) Function
Starts a test operation under the predetermined conditions. This function is
used to verify a newly created program and to restart an interrupted program.
(2) Procedures
(a) Step 1: Setting of running conditions.
Set the conditions for executing the file selection, run mode selection speed
override setting.
(b) Step 2: Command selection.
Press the NEXT key repeatedly until [RUN] is displayed in the menu. Press
the corresponding function key then.
M O D E : T E A C H I N G / C O N T T E S T P R O
L :
O : 20%
M : F REE
S : S TOP
R E SET
R U N
E D I T D E D I T S E L R U N F I L E >
STE 80720
– 6-13 –
To Next Page
Loading...
