OPERATOR’S MANUAL
series Robot Controller
Enter "TRANS00020" and press the EXE key. The display changes as
follows:
T R A N S S E L E C T I O N [ 4 / 1 2 ]
. w o r l d 1 0
w T R A N S 0 0 0 0 1 0
T R A N S 0 0 0 0 2 5
T R A N S 0 0 0 2 0 0
t T R A N S 0 0 0 0 3 0
T R A N S 0 0 0 2 0
S A V E P R G P Y L D W O R K T O O L >
(3) Cautions
• For the newly added coordinate data, zero (0) is set for all elements.
• A data is added to just below the main cursor.
• When you have pressed the ESC key without specifying the name, addition of
the new data is canceled and the system returns.
STE 80720
– 5-53 –
To Next Page
Loading...
