OPERATOR’S MANUAL
series Robot Controller
Press the EXE key, and the coordinate name is replaced by the newly
specified name. The following display appears.
T R A N S 0 0 0 2 2 [ 3 / 11]
X : 5 0 0 . 0 0 0
Y : 0 . 0 0 0
Z : 0 . 0 0 0
C : 0 . 0 0 0
5 0 0 . 0 0 0
S A V E T E A C H D I R W O R K F I N D >
The main cursor moves to the X data area. If the input name is illegal, a
message saying "ILLEGAL NAME" is displayed on the command line and no
data is changed. If the specified name already exists, a message of
"DUPLICATE NAME" is displayed on the command line and no data is
changed.
STE 80720
– 5-70 –
To Next Page
Loading...
