Toshiba TS3000 Series - Page 211

OPERATOR’S MANUAL
series Robot Controller
6.8.2 Step Reset
(1) Function
Resets all execution conditions (excluding variables) for a current file and
allows execution of that program from the top.
This function is useful to set the repetitive counts in a variable and execute the
remaining counts.
(2) Procedures
(a) Step 1: Command selection.
Press the NEXT key repeatedly until [RESET] is displayed in the menu, and
press the corresponding function key.
M O D E : T E A C H I N G / C O N T T E S T P R O
L : 28
O : 20%
M : F REE
S : S TOP
C O NT
M O D E O V R D R E S E T D O W A T C H >
Select [STEP].
M O D E : T E A C H I N G / C O N T T E S T P R O
L : 28
O : 20%
M : F REE
S : S TOP
C O NT
R E S E T : S T E P
P R O G C Y C L E S T E P S I G S E L
STE 80720
– 6-24 –