OPERATOR’S MANUAL
series Robot Controller
(3) Cautions
• In the program reset mode, all variables used in the program are reset. If
you do not wish to the variables, use the step reset function instead.
• If you do not wish to execute the setting of initial conditions at the head of the
program, use the cycle reset instead.
• In the cycle reset mode, use label RCYCLE in a desired step of the main
program.
• EX. ETHER function is provided as standard in TS3000 and as an option in
TSL3000.
STE 80720
– 8-17 –
To Next Page
Loading...
