Toshiba TS3000 Series - Page 288

OPERATOR’S MANUAL
series Robot Controller
(b) Step 2: Command selection.
Press [COPY].
If you press the ESC key without any character input in the step below, you
can exit this mode.
For the operation of each function key, see Para. 6.2.
Press the USB and you can select a file in the USB drive from the source
files.
F I L E C O P Y F R O M ( 0 0 1 / 0 2 0 )
A B C 2 5 7 F e b – 0 5 – 2 0 0 8
F I L E 0 0 0 2 5 6 F e b – 1 3 – 2 0 0 8
F I L E 0 0 1 0 1 2 3 4 M a r – 2 4 – 2 0 0 8
P I C K 0 0 2 4 . P R O 4 5 6 J u n – 1 5 – 2 0 0 8
T E S T P R O 1 3 2 5 J u l – 1 2 – 2 0 0 8
N A M E T I M E I N P U T U S B
(c) Step 3: Input of source file name.
Select a desired source file name, using the cursor, then press the EXE key.
The file name thus selected is displayed on the command line. If it is OK,
press the EXE key. It is also possible to change the file name by deleting
one (1) character by means of the BS key or all characters by means of the
ESC key.
: A B C

(d) Step 4: Input of copied file name.
Select a file name where you wish to copy the source file.
If you press the ESC key without any character input in the following step, the
system returns to the source file name input mode.
R A M : F I L E C O P Y T O R A M ( 0 0 1 / 0 2 0 )
A B C 257 Feb - 0 5 - 2008
F I L E 0 0 0 2 5 6 F e b - 1 3 - 2 0 0 8
F I L E 0 0 1 0 1 2 3 4 M a r - 2 4 - 2 0 0 8
P I C K 0 0 2 4 . P R O 4 5 6 J u n - 1 5 - 2 0 0 8
T E S T P R O 1325 Ju l - 1 2 - 2008
N A M E T I M E I N P U T U S B
STE 80720
– 9-5 –