OPERATOR’S MANUAL
series Robot Controller
If the copied file name specified already exists, the system waits for your
answer, displaying a message saying "Already exist. Delete?".
C o p y R : A B C - > R : A B C D ?
l r e a d y e x i s t . D e l e t e ?
O K T H E N < E X E >
If you wish to delete the already registered file, press the EXE key. If you do
not wish to delete it, press the ESC key.
If the copy source file name is identical to the copy target file name, the error
message "ILLEGAL OPERAND" is displayed, and the operation is canceled.
C o p y R : A B C - > R : A B C D ?
I L L G A L O P E R A N D ! !
H I T A N Y K E Y
(3) Cautions
• If the size of the copying data exceeds the memory capacity as a result of the
copy operation, an error message of "RAM file I/O error" is displayed.
• If the number of files registered in the RAM drive exceeds the limit by the
copy operation, the system waits for key input, displaying an error message of
"MTX file I/O error" or "RAM file I/O error".
• Delete any unnecessary file or files and try again.
• Unless the source file exists, an error message saying " File name Not
found" is displayed, and this operation becomes invalid.
• You cannot copy a file to the file selected as the execution file. When this
happens, an error message saying " File name file already selected" is
displayed.
STE 80720
– 9-7 –
To Next Page
Loading...
