23-04 Occurrence
Array [10]
Option: Function:
Select which day(s) the Timed Action applies to. Specify working/non-
working days in par.0-81
Working Days, par.0-82 Additional Working
Days and par.0-83 Additional Non-Working Days.
[0] * All days
[1] Working days
[2] Non-working days
[3] Monday
[4] Tuesday
[5] Wednesday
[6] Thursday
[7] Friday
[8] Saturday
[9] Sunday
23-1* Maintenance
Wear and tear calls for periodic inspection and service of elements in the application, e.g. motor bearings,
feedback sensors and seals or filters. With Preventive Maintenance the service intervals may be programmed
into the frequency converter. The frequency converter will give a message when maintenance is required. 20
Preventive Maintenance Events can be programmed into the frequency converter. For each Event the following
must be specified:
• Maintenance item (e.g. “Motor Bearings”)
• Maintenance action (e.g. “Replace”)
• Maintenance Time Base (e.g. “Running Hours” or a specific date and time)
• Maintenance Time Interval or the date and time of next maintenance
Note
To disable a Preventive Maintenance Event the associated par.23-12
Maintenance Time Base must be set to
Disabled
[0].
Preventive Maintenance can be programmed from the keypad, but use of the PC-based Trane Drive Utility is
recommended.
Parameter Description
224 TR200 Programming Guide
To Next Page
Loading...
