0-74 DST/Summertime
Option: Function:
Choose how Daylight Saving Time/Summertime should be handled. For
manual DST/Summertime enter the start date and end date in par.
0-76
DST/Summertime Start and par.0-77 DST/Summertime End.
[0] * Off
[2] Manual
0-76 DST/Summertime Start
Range: Function:
0 N/A* [0 - 0 N/A] Sets the date and time when summertime/DST starts. The date is pro-
grammed in the format selected in par.0-71
Date Format.
0-77 DST/Summertime End
Range: Function:
0 N/A* [0 - 0 N/A] Sets the date and time when summertime/DST ends. The date is pro-
grammed in the format selected in par.0-71
Date Format.
0-79 Clock Fault
Option: Function:
Enables or disables the clock warning, when the clock has not been set
or has been reset due to a power-down and no backup is installed.
[0] * Disabled
[1] Enabled
0-81 Working Days
Array with 7 elements [0] - [6] displayed below parameter number in display. Press OK and step between elements by means of
▲
and
▼
buttons on the keypad.
Option: Function:
Set for each weekday if it is a working day or a non-working day. First
element of the array is Monday. The working days are used for Timed
Actions.
[0] * No
[1] Yes
0-82 Additional Working Days
Array with 5 elements [0] - [4] displayed below parameter number in display. Press OK and step between elements by means of
▲
and
▼
buttons on the keypad.
Range: Function:
0 N/A* [0 - 0 N/A] Defines dates for additional working days that normally would be non-
working days according to par.0-81
Working Days.
0-83 Additional Non-Working Days
Array with 15 elements [0] - [14] displayed below parameter number in display. Press OK and step between elements by means
of
▲
and
▼
buttons on the keypad.
Range: Function:
0 N/A* [0 - 0 N/A] Defines dates for additional working days that normally would be non-
working days according to par.0-81
Working Days.
Parameter Description
56 TR200 Programming Guide
To Next Page
Loading...
