Triple E COMMANDER Series - RANGE AND OVEN OPERATION

13-2
13.1.3 EXTERIOR FRIDGE ACCESS
This compartment allows access to the refrigerator for
cleaning, inspection, maintenance and service. It is
good practice to open the compartment door once in
a while to make sure that the area is free of any debris
that might hinder air circulation.
13.2 RANGE AND OVEN
Fig. 13-2 EXTERIOR FRIDGE ACCESS
COMMANDER / EMBASSY
Fig. 13-3 RANGE COOK TOP
It is not safe to use cooking appliances for comfort
heating. Cooking appliances need fresh air for safety
operation. Before operation:
1. Open overhead vent or turn on exhaust fan.
2. Open window.
WARNING
(if equipped)
Both the range and the oven operate on LP gas. The
oven has a pilot light which can be lit to start the oven
burner at any time.
13.2.1 LIGHTING BURNERS
To Light The Range:
1. Turn the burner control knob to “on”.
2. Turn the piezo ingition knob until the burner
ignites. If the burner does not ignite within 10
seconds, turn the burner control knob o: wait 5
minutes and try again.
3. Adjust the level of the ame by turning the control
knob.
Turn the igniter knob immediately after turning
the burner on to prevent a gas build-up. Excess
gas can cause a are-up when lit.
WARNING
13-2
13.1.3 EXTERIOR FRIDGE ACCESS
This compartment allows access to the refrigerator for
cleaning, inspection, maintenance and service. It is
good practice to open the compartment door once in
a while to make sure that the area is free of any debris
that might hinder air circulation.
13.2 RANGE AND OVEN
Fig. 13-2 EXTERIOR FRIDGE ACCESS
COMMANDER / EMBASSY
Fig. 13-3 RANGE COOK TOP
It is not safe to use cooking appliances for comfort
heating. Cooking appliances need fresh air for safety
operation. Before operation:
1. Open overhead vent or turn on exhaust fan.
2. Open window.
WARNING
(if equipped)
Both the range and the oven operate on LP gas. The
oven has a pilot light which can be lit to start the oven
burner at any time.
13.2.1 LIGHTING BURNERS
To Light The Range:
1. Turn the burner control knob to “on”.
2. Turn the piezo ingition knob until the burner
ignites. If the burner does not ignite within 10
seconds, turn the burner control knob o: wait 5
minutes and try again.
3. Adjust the level of the ame by turning the control
knob.
Turn the igniter knob immediately after turning
the burner on to prevent a gas build-up. Excess
gas can cause a are-up when lit.
WARNING