Triple E COMMANDER Series - JUMP STARTING PROCEDURES

8-3
8.5 JUMP STARTING
When the vehicle batteries do not have sucient
charge to start the engine, there are two ways to start
the unit:
1. Battery Boost Switch:
Depress and hold the switch on the left side of
the dash to connect the coach batteries into the
starter circuit to use all batteries for starting. Re-
lease the switch when the engine starts. This will
disconnect the battery from the circuit.
2. Jump Starting:
Open the electrical utility compartment and
connect the jumper cables to the battery posts.
Always connect positive to positive. The negative
should be connected from the negative terminal
of the battery on the vehicle providing the boost
to the chassis of the vehicle needing the boost.
COMMANDER / EMBASSY
Fig. 8-2 STARTING SWITCH
Fig. 8-3 CHASSIS BATTERY
NOTE
See section 10.3.4 for battery mainte-
nance information.
1
8-3
8.5 JUMP STARTING
When the vehicle batteries do not have sucient
charge to start the engine, there are two ways to start
the unit:
1. Battery Boost Switch:
Depress and hold the switch on the left side of
the dash to connect the coach batteries into the
starter circuit to use all batteries for starting. Re-
lease the switch when the engine starts. This will
disconnect the battery from the circuit.
2. Jump Starting:
Open the electrical utility compartment and
connect the jumper cables to the battery posts.
Always connect positive to positive. The negative
should be connected from the negative terminal
of the battery on the vehicle providing the boost
to the chassis of the vehicle needing the boost.
COMMANDER / EMBASSY
Fig. 8-2 STARTING SWITCH
Fig. 8-3 CHASSIS BATTERY
NOTE
See section 10.3.4 for battery mainte-
nance information.
1