Triple E COMMANDER Series - WATER PUMP INITIAL START-UP

To Next Page

To Previous Page

12-4

COMMANDER / EMBASSY

Fig. 12-4 WATER FILTER

12.1.4 WATER PUMP FILTER

Before water can enter the various outlets in your

motorhome it ows through a water lter. This lter is

located on the water pump. The water pump is located

either in the service module on the Commander and

under the bed on the Embassy.

Check the water lter periodically and clean or replace it

at least annually to assure a clean supply of water.

12.1.5 WATER SYSTEM ACCESS

The water system compartment is designed with a hole

in the bottom to provide access to the compartment for

the water line. Route the hoses through this hole and

close the compartment door when at a campsite.

12.1.6

WATER PUMP INITIAL START-UP

1. Make sure all drain valves are closed including the

water heater valve.

2. Turn water pump switch o.

3. Fill water tank.

4. Open faucets, both hot and cold.

5. Turn pump switch on.

6. Close each faucet (cold and hot) as soon as water

ows steadily.

7. Check to see that pump stops after all faucets are

closed.

8. Pump is now ready for automatic operation. It will

start whenever a faucet is opened.

Fig. 12-5 ACCESS DOOR (COMMANDER ONLY)