9-4
COMMANDER / EMBASSY
Fig. 9-5 ROOM EXTENDED
3. To Extend (Main & Galley Slide):
Turn the power lock key to “on’, press and hold
the control switch located above the entrance
door until it is fully extended. Make sure it is fully
extended so that all weather seals will be in their
proper alignment.
4. To Retract (Main & Galley Slide):
Be sure that there are no obstructions inside or
outside the motorhome that would prevent easy
operation. Turn ignition to accessory position
and turn the jack control panel on. Press and
hold the control switch on the slide out control
until the room is back in place. Install the travel
locks and prepare the rest of the motorhome for
travel. Turn key switch on the slide out control to
the "o" position and remove the key.
5. To Extend (Bed & Wardrobe Slide):
Press and hold the control switch located on the
bedroom or hall wall until it is fully extended.
Make sure it is fully extended so that all weather
seals will be in their proper alignment.
6. To Retract (Bed & Wardrobe Slide):
Besure that there are no obstructions inside or
outside the motorhome that would prevent easy
operation. Press and hold the control switch until
it is fully retracted. Install the travel locks.
CAUTION
Never move your motorhome with the slide-out
extended. Severe damage could result. Before
moving the motorhome, the slide-out must be
securely retracted and all travel locks fastened.
7. Set-Up:
Service by a professional, adjustments, regular
maintenance and replacement of weather seals
as needed will extend the life and comfort of your
slide-out unit.
8. Seals:
Cracked and worn weather seals may allow
moisture and dirt to enter your motorhome and
cause premature deterioration of the interior.
Check the seals carefully in fall and in spring and
have them replaced if necessary.
Extensive travel and use in severe weather
conditions may cause a more rapid deterioration
of some components, especially weather seals. In
some extreme circumstances these may need to be
replaced.
9-4
COMMANDER / EMBASSY
Fig. 9-5 ROOM EXTENDED
3. To Extend (Main & Galley Slide):
Turn the power lock key to “on’, press and hold
the control switch located above the entrance
door until it is fully extended. Make sure it is fully
extended so that all weather seals will be in their
proper alignment.
4. To Retract (Main & Galley Slide):
Be sure that there are no obstructions inside or
outside the motorhome that would prevent easy
operation. Turn ignition to accessory position
and turn the jack control panel on. Press and
hold the control switch on the slide out control
until the room is back in place. Install the travel
locks and prepare the rest of the motorhome for
travel. Turn key switch on the slide out control to
the "o" position and remove the key.
5. To Extend (Bed & Wardrobe Slide):
Press and hold the control switch located on the
bedroom or hall wall until it is fully extended.
Make sure it is fully extended so that all weather
seals will be in their proper alignment.
6. To Retract (Bed & Wardrobe Slide):
Besure that there are no obstructions inside or
outside the motorhome that would prevent easy
operation. Press and hold the control switch until
it is fully retracted. Install the travel locks.
CAUTION
Never move your motorhome with the slide-out
extended. Severe damage could result. Before
moving the motorhome, the slide-out must be
securely retracted and all travel locks fastened.
7. Set-Up:
Service by a professional, adjustments, regular
maintenance and replacement of weather seals
as needed will extend the life and comfort of your
slide-out unit.
8. Seals:
Cracked and worn weather seals may allow
moisture and dirt to enter your motorhome and
cause premature deterioration of the interior.
Check the seals carefully in fall and in spring and
have them replaced if necessary.
Extensive travel and use in severe weather
conditions may cause a more rapid deterioration
of some components, especially weather seals. In
some extreme circumstances these may need to be
replaced.
To Next Page
Loading...
