TX9165 User Manual
TX9165-UM-EN-07 13
1.7 Sentro Sensing Modules
Plug-in pre-calibrated eModules and rModules with standardised output data.
• Each eModule and rModule stores all the necessary data about its type,
identification, sensing range and specific calibration. This data is automatically
recognised by Sentro 8 Sensorstation when the eModule or rModule is
plugged into the module bay
• The eModule and rModule are pre-calibrated so they can be replaced at any
time with a replacement sensing module - usually of the same type, but an
alternative may be inserted if required
• User configurable coding slots at each module bay can be individually
configured using coding stops to prevent invalid sensing module combinations
• The eModule and rModule will identify itself when plugged into the module
bay, auto configuration will take place and the sensing module type will display
on the LCD screen
• All Sentro eModules and rModules have two output alarm signals for General
alarm and High alarm. Default values are entered during manufacture and
these can be changed to preferred values
• There are two types of Sentro sensing module:
Sentro eModule
Integral Gas Sensor
Sentro rModule
Terminals for Connecting Remote Sensors
www.trolex.com
To Next Page
Loading...