Trolex Sentro 8 - Assign Fault

66 TX9165-UM-EN-07
4.4.3 Assign Fault
Each input channel A to H has a fault alarm
output state:
• Analogue input signal over range
• Analogue input signal under range
• Module fault
To Access Assign Fault
From the Sentro eModule Setup Menu,
use the navigation keypad, scroll to Assign
Fault and select OK.
If a Security Code has been enabled you will
be prompted to enter it, enter the Security
Code and select OK.
The screen prompts are as follows:
• Cursor
• Power-up the selected relay
• Reset a latched relay
• Audio alarm severity
www.trolex.com