Trolex Sentro 8 - Sentro Rmodule Setup

TX9165 User Manual
TX9165-UM-EN-07 69
4.5 Sentro rModule Setup
This displays more detailed information
about the configuration of individual rModule
channels.
From the Base Screens, use the navigation
keypad and scroll to the required channel
E, F, G or H. Press and hold down the left
arrow on the navigation keypad. After a few
seconds the Sentro rModule Setup Menu
will appear. The options are as follows:
• Calibrate - if PT100 fitted
• Scaling
• Sig Fig
• Lower
• Upper
• Units
• Update
• Tex t
• Setpoint 1
• Activate
• Level
• Assign To
• Hysteresis
• On Delay
• Off Delay
• Setpoint 2
• Activate
• Level
• Assign To
• Hysteresis
• On Delay
• Off Delay
• Assign Fault
• Assign To
• Status
• Exclude
www.trolex.com