84 TX9165-UM-EN-07
6.2 Absent Sensing Module
Message
When the Sentro 8 Sensorstation is first
switched on, or a sensing module is removed
during normal operation, the screen will
display the message:
• Sensor Missing
If a sensing module has not been fitted
within a period of 10 seconds, the screen will
display the message:
• Not Fitted
6.3 Replacing a Sentro Sensing
Module
If a Sentro sensing module is removed and
replaced with a sensing module of the same
type, then the Sentro 8 Sensorstation will
first request permission to accept the new
sensing module configuration or write the
configuration data of the previous sensing
module into the new sensing module.
If a Sentro sensing module is removed and
replaced with a sensing module of a different
type, then the Sentro 8 Sensorstation will
first request permission to proceed.
Section 7.4
www.trolex.com
To Next Page
Loading...