90 TX9165-UM-EN-07
Use the navigation keypad, scroll to Set or
Quit and select OK.
Checkpoint
• Confirmation of eModule or rModule
setup data will be requested whenever
a eModule or rModule is replaced.
• If an eModule or rModule is replaced
by the same type of sensing module,
then the existing data would normally
be used. Overwrite the data if required
or if a different type of eModule or
rModule is loaded.
• Ensure that new coding stops are
fitted into a replacement eModule or
rModule where a user specific code
has been previously defined.
www.trolex.com
To Next Page
Loading...