4–28
NOTE
The latitude and longitude display, showing the
location of the measurement, is available only on
Model 3440 gauges equipped with the optional GPS
and is shown only when it is enabled.
The latitude and longitude values denote the quality
of the location fix. If WAAS information is available
during a gauge measurement, the latitude and
longitude will be displayed to the nearest hundredth
(1/100) of a second.
If a GPS location is determined, but the WAAS
information is unavailable, the latitude and longitude
will be displayed to the nearest tenth (1/10) of a
second.
If the GPS receiver cannot determine a location, the
latitude and longitude will be denoted as 0. For more
information on GPS accuracy, see Appendix H.
If a project is active and the Auto-Store function (see page 8–12)
is enabled, press ¢ESC² or ¢ENTER/START² to continue. For each
measurement, the gauge can store a location description of up
to 12 characters, as well as a note of up to 15 characters. Follow
the prompts to enter location information and/or a note.
If a project is active but the Auto-Store function is not enabled:
f Press ¢STORE² to store the results. Follow the prompts to
enter location information and/or notes. For more
information on storing results manually, see page 8–14.
f Press ¢ESC² to return to the Ready screen without storing
the results. Note that, until another measurement has been
taken, the results can be recalled as described on page 4–31
and stored later.
To Next Page
Loading...
Need help?
General
