Troxler RoadReader 3430 User Manual

Model 3440 Appendix A–7
Error Messages
The following table displays a list of the gauge error messages,
as well as the possible causes and recommended solutions for
each message.
Table 3. Error Messages
Error Message
Possible Causes
Solution
Bad Checksum!
Default Settings
Restored
Gauge settings and/or
project data stored in
memory have been
corrupted and default
(factory) settings have
been restored.
Set up user preferences (such
as measurement mode, count
time, and so on) as described
in Chapter 3.
Cannot Close File
after Writing.
An error occurred
when attempting to
store data to a USB
flash drive.
Try to store the data again. If
error recurs, try a different USB
flash drive.
Cannot Initialize
Media
An error occurred
when trying to access
the USB flash drive.
Check that the USB flash drive
is installed properly. If error
recurs, try a different USB flash
drive.
Cannot Open
Printer
An error occurred
when trying to
communicate with a
USB printer.
Check that the printer is
powered on and is properly
connected to the USB port.
Ensure that the printer is
compatible with the gauge. A
list of compatible USB devices
is available at:
www.troxlerlabs.com/products
Cannot Write to
the File
An error occurred
when attempting to
store data to a USB
flash drive.
Try to store the data again. If
error recurs, try a different USB
flash drive.
Cannot Write to
the Printer
An error occurred
when trying to
communicate with a
USB printer.
Check that the printer is
powered on and is properly
connected to the USB port.
Ensure that the printer is
compatible with the gauge. A
list of compatible USB devices
is available at:

Troxler RoadReader 3430 Specifications

General

Brand	Troxler
Model	RoadReader 3430
Category	Measuring Instruments
Language	English