Model 3440 4–31
If the GPS receiver cannot determine a location, the
latitude and longitude will be denoted as 0. For more
information on GPS accuracy, see Appendix H.
If a project is active (see Error! Reference source not found.)
and the Auto-Store function (see page 8–12) is enabled, press
¢ESC² or ¢ENTER/START² to continue. For each measurement,
the gauge can store a location description of up to 12 characters,
as well as a note of up to 15 characters. Follow the prompts to
enter location information and/or a note.
If a project is active but the Auto-Store function is not enabled:
f Press ¢STORE² to store the results. Follow the prompts to
enter location information and/or notes. For more
information on storing results manually, see page 8–14.
f Press ¢ESC² to return to the Ready screen without storing
the results. Note that, until another measurement has been
taken, the results can be recalled as described on page 4–31
and stored later.
Lift the gauge from the test site by the source rod handle.
This returns the source rod to the SAFE position. When not
taking readings, always keep the source rod in the SAFE
position.
To view the results of the most recent measurement, press the
¢RECALL² key from the Ready screen. The Recall function can
also be used to view the gauge counts from the most recent
measurement.
To return to the Ready screen, press the ¢ENTER/START² key.
NOTE
The ¢RECALL² key is active only when the
Ready
screen is displayed.
To Next Page
Loading...
Need help?
General
