Erase Thin Layer Special Calibrations
At the Thin Lift Special menu shown on page 6–16,
press 〈5〉 Erase.
The gauge displays:
From this menu, the operator can erase either a single thin layer
special calibration or all thin layer special calibrations.
To erase a single thin layer special calibration, use the arrow keys to
scroll through the thin layer special calibrations names displayed on
the first line. When the gauge displays the thin layer special
calibration to be erased, press
〈1〉. At the Are you sure . . .
prompt, press the
〈YES〉 key. The gauge erases the thin layer special
calibration and returns to the Ready screen.
To erase all thin layer special calibrations, press 〈2〉. At the Are
you sure . . . display, press the
〈YES〉 key. The gauge erases all
the thin layer special calibrations and returns to the Ready screen.
1-
Erase This Sp Cal
2-
Erase All
Sp
Cal
To Next Page
Loading...
