MEASURING THE MOISTURE. To measure the moisture, press
〈1〉 Measure Moisture.
Prepare the test site as described on page 4–6. Place the gauge on
the test site and position the source rod in the measurement position.
Press the
〈START〉 key.
The gauge displays the progress of the measurements. After taking
each reading, the gauge displays the results. To continue to the next
reading, press the
〈START〉 key. After the last reading, press the
〈ENTER〉 key. If the true moisture has not yet been stored, the
gauge displays:
To enter the true moisture later, create a partial offset by pressing
〈1〉. To enter the true moisture now, press 〈2〉 and follow the gauge
prompts to complete the offset.
Surface To Be Tested
Press START For 4
One-Minute Counts
1- Store Partial
Moisture Offset
2- Input True Moist
To Next Page
Loading...
