F3200 Operator's Manual Document No: LT0119
Network Systems
Page 11-26 29 July 2002 Issue 2.04
Testing a Range of Network Zones (Continued)
The display will show the selected range of zones, i.e. zone nnnnn to zone mmmmm
inclusive, plus a list of options as follows:
1: Alarm Test
2: Fault Test
3: Operate Test
4: Auto Reset Test
5: Abort Test
Press numeric key 1 to 5 to select the test and then press the ACK key to initiate the
command.
All zones in the range must be of the same type, i.e. all alarm zones, or all relay zones,
etc.
Alarm Test, Fault Test, and Auto Reset Test, may be applied only to alarm zones.
Operate Test may be applied to relay zones and open collector zones. The abort test
command may be applied to any type of zone.
Not all types of FIP support test commands for a range of zones.
To Next Page
Loading...
