Document No: LT0119 F3200 Operator's Manual
Network Systems
Issue 2.04 29 July 2002 Page 11-25
Testing a Single Zone (Continued)
The LCD will display the network zone with a message saying "Sending Command".
After a brief period the message should change to "Command Accepted", and the test
will begin. Refer to Section 11.7 for a description of these and other possible LCD
messages.
If an exception occurs at the remote FIP, eg. a test failed, then an exception message
may be received indicating the reason why. Refer to Section 11.7 for a description of
Exception Messages.
11.10.6.3 Notes
(i) The effect of the test command is dependent upon the receiving FIP type, eg.
how the zones will be tested, how other zones/FIPs, etc, are affected by the
test, and so forth.
(ii) A test on a remote zone may be aborted with an abort test command (option 5
from the menu described in Section 11.10.6.2).
(iii) If the network zone number(s) entered correspond to local zone(s), the
LCD/keypad test menu continues as if local zone number(s) had been entered.
The network zone test menu is not used, thus no network messages are
displayed.
Refer to Sections 7.5, 8.5, 8.9 and 8.10 for details on local tests.
(iv) If an F3200 or NDU receives a test command from a remote panel it will
process it as if the test command had been initiated by a local operator.
11.10.6.4 Testing a Range of Network Zones
To test a range of network zones, from the base display press:
To Next Page
Loading...
