Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
4 - 64 Configuration Issue 13 February 2001
Timer Events Configure → Timer Events. There are no Timer Events configured in
the system. Users can add Timer events (statements that become “true”
or active at specific times) that can be used in conjunction with Control
Relays in Peripheral Monitoring.
Configuration
From a Remote
Terminal
When Galaxy SC’s Intelligent Controller feature has been provided, you
can use a remote terminal to perform all of the configuration and data
accessing requirements for the plant previously described for the front
panel display. In fact, some of the more advanced Intelligent features
can only be done from a terminal.
T1.317 Command
Language
The T1.317 command language described in Appendices A, B, and C is
the “human to machine” interface used for this communication, but you
may also operate Galaxy SC with a more user-friendly interface
package, Lineage 2000 EasyView, which combines both a
communication package and an easy-to-use Microsoft
®
Windows
interface.
Connecting a
Terminal to Galaxy
SC
You may communicate with Galaxy SC using any ANSI (American
National Standards Institute) character-based terminal, including
terminal emulators for personal computers. Communication using the
Lineage 2000 EasyView software (over the Local or Modem ports)
requires a personal computer running Microsoft
®
Windows.
Local Port
Connect a terminal to Galaxy SC using a serial cable to the 25-pin
RS-232 Local port inside the front cover at the left side of the controller.
Route this cable under the bottom of the front door to allow it to close
with this cable connected. A second 25-pin RS-232 for the Intelligent
Local port is located on the rear of the Galaxy SC for occasions where
this provides more convenient local access. These two ports are
connected in parallel and only one may be active at any time. To use this
port for configuration purposes, set DIP switch SW203 on the BJH
Intelligent controller as follows:
SW203-2 OPEN Terminal Mode
SW203-3 CLOSED Allows Configuration of Local/Aux/Modem Port
SW203-6 CLOSED Full Access via Local Port

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English