Tyco Electronics Galaxy SC Controller J85501F-1
6 - 10 Operation Issue 13 February 2001
Diagnostics You can view some diagnostic messages from the front panel. Press the
MENU key to bring up the MAIN menu, move the cursor to DIAG field,
press ENTER key to bring up the DIAG menu:
Selecting the RECT field displays rectifier diagnostics; the PLANT
field is for system diagnostics; the RPM is for Remote Peripheral
Monitoring modules; EXPR is for program lines in the UDEs, Derived
Channel and Control Relay; ALL is for all diagnostics in the system.
Move the cursor to the field for which you want to run diagnostics; press
ENTER to proceed. If no problems are found, the front panel displays
the “NO DIAGNOSTICS DATA” message. Otherwise it will list all
problems found on the screen. For more than one screen of data (8 lines),
use the UP and DOWN keys to display additional messages.
EasyView
Common
Access and
Control
Functions
ACO Operation
(Alarm Cut Off)
ACO is initiated within EasyView with the following path from the
Main Menu: Control → ACO. The action taken by Galaxy SC is
controlled through the configuration of ACO, completed under
Configure → Alarm Cut-Off (ACO). Refer to Section 7, Features, for a
complete description of the ACO feature.
Alarm Test
Operation
EasyView path: Main →Control →Alarm Test. Again, the action taken
is under control of the Alarm Test configuration, completed under
Configure → Alarm Test. Refer to Section 7, Features, for a complete
description of the Alarm Test feature.
Backup/Restore EasyView path: File → Backup or File → Restore
DIAG
ALL
RECT
PLANT
RPM
EXPR
To Next Page
Loading...
Need help?
General
