Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
6 - 18 Operation Issue 13 February 2001
configuration depends on the remote peripheral monitors available in
the system. For help in creating user defined events please see the
section entitled “T1.317 User-Defined Event Management” in this
manual.
LIN B01 VDC,C101 link remote monitor C101 to the DC
voltage attribute
LIN B01 ACH,C102 link remote monitor C102 to the charge
current attribute
LIN B01 ADS,C202 link remote monitor C202 to the
discharge current attribute
LIN B01 TPS,C702 link remote monitor C702 to the
battery section temperature attribute
LIN B01 FST,U0001 link user-defined event U0001 to the
battery section fuse status alarm
attribute
Battery Parameter
Configuration
Part of the battery parameter configuration is done at the plant level. The
following commands configure these parameters:
CHA DC1,CPS=24 Change the cells per battery string to 24
CHA DC1,NST=2 Change the number of battery sections to
2
CHA DC1,BTY=“VR-125" Change the plant battery type to VR-125
The following commands configure parameters that apply to battery
management in general. The attributes are located in the Battery Reserve
object.
CHA BR1,TTH=80 Change the high temperature threshold to
80 degrees
CHA BR1,CLE=1 Change the recharge current limit state to
enabled
CHA BR1,CLT=800 Change the recharge current limit
threshold to 800 A
CHA BR1,CEV=1.75 Change the end volts per cell to 1.75 V
The following commands configure battery section level parameters
using battery section 1 as an example:
CHA B01,CON=CN1 Change the battery section contactor to
CN1
CHA B01,NST=1 Change the number of strings in this
section to 1
CHA B01,BTY=“VR-125" Change the plant battery type to VR-125

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English