Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Operation 6 - 31
To clear the rectifier state history, issue the following command:
CLH REC,STT
To review the incidents of rectifier and plant alarms, issue the following
command:
HIS DC1
To clear the rectifier and plant alarm history, issue the following
command:
CLH DC1
Rectifier
Management
The T1.317 interface allows configuration and management of all the
rectifier parameters supported by the system. The information below
provides examples of how to configure various rectifier parameters.
The following commands configure show how to configure rectifier 1 as
a 570A rectifier and rectifier 9 as a commercial rectifier. Note that some
of the commands are only needed when using the commercial rectifier
interface.
Normal rectifier configuration:
CHA G01,TYP=“570A” change rectifier 1 to a 570A type rectifier
CHA G01,SEQ=1 enable rectifier 1 to be used when
sequencing
Commercial rectifier configuration:
CHA G09,TYP=“G400" change rectifier 9 to a 400A
commercial rectifier
CHA G09,MNT=“CC” change rectifier 9 manual off signal to
a contact closure
CHA G09,SHV=50 change rectifier 9 shunt voltage to 50 mV
Some rectifier parameters are configured at the plant level. The
following commands illustrate how to configure some of these
parameters:
CHA DC1,RSE=1 enable automatic rectifier restart after RFA
CHA DC1,RSQ=1 enable rectifier sequencing
CHA DC1,ROT=48 change the all rectifier on threshold to 48 V
CHA DC1,ROD=10 change the rectifier on delay to 10 minutes

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English