Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 T1.317 Interface Appendix A - 9
PAS Change a password
Syntax:PAS x[,password,password]
where x is U for user password
S for super-user password
A for administrator password
T for TL1 password
This command allows passwords to be changed at the administrator security
level only. If the passwords are not included in the command line, the controller
will respond by prompting the user twice for the new password. If both pass-
words match and are valid the password for the requested security level will be
changed.
REM Remark
Syntax:REM text
where text is a series of any characters terminated by a carriage return or new-
line character.
This command is useful for embedding comments into a backup file or any file
used in downloading a set of commands to the Galaxy. The remainder of the
command line is ignored after the REM command header.
RSDATE Interactively set the system date and time
Syntax: RSDATE
This command prompts the user to enter a new data and time separated by a
semicolon.
UNL Unlink an object from a user linkable attribute
Syntax: UNL objpath,objid<,objid>*
In this command, objpath leads to a linkable attribute and objid is the identifier
of an object linked to that attribute. For example, UNL DC1 TL1,TL001 will un-
link the TL001 object from the TL1 attribute of the DC plant. Only objects linked
using the LIN command can be unlinked. The LIN report command or STA
command can be used to list the links to an object. The following example adds
a user defined event to the power system manager object, PS1, and then un-
links it:
ADD UDE,U0001 Add a user defined event identified as U0001
ADD PS1,RMHOT Add a linkable attribute called RMHOT to PS1
LIN PS1 RMHOT,U0001
Link U0001 to PS1 at the RMHOT linkable
attribute
UNL PS1 RMHOT,U0001
Unlink U0001 from PS1 at the RMHOT
linkable attribute
BACKUP Backup the system configuration
Syntax:BACKUP [X|A]
X indicates XMODEM transfer
A indicates ASCII transfer
This command allows the super-user or administrator to backup the system
configuration. If the optional arguments are not included, the controller re-
sponds by prompting the user for either an ASCII or XMODEM file transfer or
to cancel the backup operation. The backup command output is a series of
ADD, LIN, and CHA commands.
When using the ASCII option it is useful to use software flow control (XON,
XOFF) especially at faster baudrates. When using the XMODEM option soft-
ware flow control must be turned off and the data bits attribute must be set to 8.

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English