Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
Appendix A - 10 T1.317 Interface Issue 13 February 2001
RESTORE Restore the system configuration
Syntax:RESTORE [X|A]
X indicates XMODEM transfer
A indicates ASCII transfer
This command allows the administrator to restore a system configuration. If the
optional arguments are not included, the controller responds to this command
by prompting the user for either an ASCII or XMODEM file transfer or to cancel
the restore operation. This command is intended to take a controller from its
default configuration to a custom configuration. It should be used after software
upgrade or backup battery power loss. If commands in the custom configura-
tion file conflict with the current configuration of the system then those com-
mands will be ignored.
The restore command executes the commands in the backup file as if they had
been entered from the command line with the exception that output is not sent
to the user terminal. When using the ASCII option it is useful to use software
flow control (XON, XOFF) especially at faster baudrates. When using the
XMODEM option software flow control must be turned off and the data bits at-
tribute must be set to 8.
UPGRADE Upgrade the Intelligent Controller software
Syntax: UPGRADE
This command allows the administrator to upgrade the to upgrade the Intelli-
gent Controller software. The controller responds to this command by prompt-
ing the user to continue or cancel. If the user chooses to continue, the
controller will enter upgrade mode. See the description of software upgrade for
more information.
Reporting
Commands
Reporting commands report the state of the system or some subset of the
system.
ALA Report active alarms.
ALI Report aliases.
ATT Report the object attributes.
CON Report the settings of configuration and operation attributes.
DIA Report diagnostic information.
HELP Report the customer service 800 number
HIS Report history information
LIN Report object links
LIS List object type information.
MET Report the value of measurement attributes.
NAL Report the number of active alarms.
NRE Report the number of active record only events.
NWA Report the number of active warnings.
NUM Report the number of objects of a given type.
ORP Report orphan objects, those without parents.
PAGE Report the page size.
PAR Report an object’s path.
REC Report active record only events.
STA Reports the value of an attribute.
SUM Report statistical data.
WAR Report active warnings.
All commands return a minimal response of .<CR><LF>
(period-carriage return-line feed). This command complete response is
an acknowledgment that the command was received and processed. If an

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English