Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 T1.317 Interface Appendix A - 13
tributes. If linkable attributes are specified on the command line, those at-
tributes must be linked to a remote peripheral monitor channel. For linkable
attributes the measurement value of the remote peripheral monitor channel is
reported. The report will include the object identifier preceded by a colon fol-
lowed by a line for each attribute using the following format: attrid=value. The
following examples report all measurement date from the DC plant and limits
the report to the DC voltage and current:
MET DC1
MET DC1,VDC,ADC
NAL/NWA/NRE Report the number of active alarms, warnings, or record-only
events
Syntax: NAL [objpath]
NWA [objpath]
NRE [objpath]
This command searches the objects that objpath leads to, and all objects
linked to these objects, for active events. The command reports the number of
active events found. If objpath is omitted, the total number of active events in
the system is reported. The following examples will report all the number of ac-
tive warnings in the entire system and the number of active alarms in just the
DC plant:
NWA
NAL DC1
NUM Report the number of objects of a given type
Syntax:NUM objtype
This command reports the number of objects of a given type that exist in the
system. The example below illustrates how this command may be used:
NUM UDEReports the number of user-defined objects that have been
added
PAGE Report the page size
Syntax: PAGE
This command returns the page size in lines set by using the PAGE command.
The page size is only value for the current login session and will be reset when
the user logs out.
PAR Report an object’s path
Syntax:PAR objpath
For this command, objpath must lead to an object identifier. The command re-
ports the complete path of the identified object. For example, PAR G01 will re-
port a parent path of DC1 REC G01 which indicates that G01 is a child of DC1
linked to the REC attribute.
ORP Report the orphan objects, those without parents
Syntax:ORP objpath
This command lists all of the objects that are not linked to a parent object. This
is useful for example, to find out which user-defined object or remote peripheral
monitoring channels are still available. If objpath is omitted, then all orphan ob-
jects are listed. If objpath is an object type specifier, then all of the orphans of
that type will be listed. The following are examples of this command.
ORP VTM Report all of the orphan voltage monitoring channels
ORP UDE Report all of the orphan user defined events
REC Report active record-only events
Syntax:REC [objpath]
This command searches the objects that objpath leads to, and all objects
linked to these objects, for active record-only events. If objpath is omitted, all

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English