1-2. REASSEMBLY
Reassemble them in reverse order of disassembly in accordance with
the following instruction.
- Installation of clutch damper and related parts.
(1) When installing the clutch damper on the flywheel,be sure to install the cotter
pin to flywheel.
(2) Apply a thin coat of molybdenum disulfide-based grease(Three bond TB1901
or equivalent) to revolving or sliding parts prior to reassembly.
(3) When installing the clutch damper on the flywheel,take care not to damage this
clutch damper.
(4) Apply an ANTI RUST 720S or equivalent after installing clutch damper in order to
prevent from rust.
5-5
Fig.5-5
To Next Page
Loading...
Need help?
General
