typical GT1790A - Page 45

-
42
-
No.
Item
Setting range
Edit unit
Remarks
S040
Crosswise compensation of needle entry of basting
This item sets the amount to move needle entry position to
the right or left when performing basting more than two
cycles.
0.0 ~ 1.0
0.1 mm
*3
S041
Compensation of left side position of basting
This item sets the amount to move the sewing reference
position of basting from the center of left overedging to the
right or left.
2.0 ~ 2.0
0.1 mm
*2, *3
S042
Compensation of right side position of basting
This item sets the amount to move the sewing reference
position of basting from the center of right overedging to
the right or left.
-2.0 ~ 2.0
0.1 mm
*2, *3
S044
Setting basting speed
This item sets the speed of basting.
400 ~ 4200
100sti / min
*3
S051
Left parallel section tension
This item sets needle thread tension at left parallel section.
0 ~ 200
1
-
S052
Right parallel section tension
This item sets needle thread tension at right parallel
section.
0 ~ 200
1
*2
S053
Left parallel section tension (1
st
cycle of double
stitching)
This item sets needle thread tension at left parallel section
of 1
st
cycle at the time of double stitching.
0 ~ 200
1
*2, *3
S054
Right parallel section tension (1
st
cycle of double
stitching)
This item sets needle thread tension at right parallel section
of 1
st
cycle at the time of double stitching.
0 ~ 200
1
*2, *3
S055
1
st
bar-tacking section tension
This item sets needle thread tension at 1
st
bar-tacking
section.
0 ~ 200
1
-
S056
2
nd
bar-tacking section tension
This item sets needle thread tension at 2
nd
bar-tacking
section.
0 ~ 200
1
*2
S057
Setting of needle thread tension at the start of sewing
This item sets needle thread tension of tie stitching at the
start of sewing.
0 ~ 200
1
-
S058
Setting of needle thread tension of basting
This item sets needle thread tension of basting.
0 ~ 200
1
*3
S059
ACT timing adjustment at the start of 1
st
bar-tacking
This item adjusts needle thread tension output start timing
at 1
st
bar-tacking section.
5 ~ 5
1 stitch
*2
S060
ACT timing adjustment at the start of right overedging
This item adjusts needle thread tension output start timing
at right overedging section.
5 ~ 5
1 stitch
*2
*1: Displayed according to the shape.
*2: Displayed when it is set to with edit. Refer to “V-12. Method of setting sewing data with/without edit” p.32.
*3: Displayed when the function is selected.