-
53
-
(2) Editing method of cycle sewing data
1) Set the mode to the input mode
Under the input mode where Set Ready LED goes
out, the continuous-sewing data entry is enabled. In
sewing mode, press Ready key ❷ to change
over the mode to input mode.
2) Set cycle data to editing state
When Edit key ❽ is pressed, the
continuous-sewing data editing display C appears on the
screen. The pattern No. D to be sewn is displayed in
reverse video. The data is editable in this state.
Press Item Selection key ❻ and then the editing
point will move and reverse sequentially. When the
editing point is carried to the last piece of data, the
additional indication pictograph is displayed if there is
an available pattern number. Move forward the editing
point from there and then the data name will become
the editing point.
In addition, press Edit key on editing point and then it
will turn to the state in which the editing point data can
be changed.
When the editing point is pattern No.
The appended indicator icon will display in selection position and now you can insert the pattern data.
When the editing point is data name
The data name will become editable.
Editing point selection sequence after pressing Item Selection key
Pattern number to be added to the
last piece of data (can only be
selected in the case an available
pattern number that can be input is
left)
To Next Page
Loading...
