typical GT1790A - Error Codes E430-E497

-
76
-
Error
code
Description
Reset method
Reset location
E485
Number of times of basting unsetting error
When the number of times of basting is not set
(OFF) for “Basting+ Cloth cutting knife shape".
Re-input by
reset
Sewing data edit screen [S034]
Basting stitch (OFF//Number of
times)
(during continuous sewing)
Standard screen
E486
Eyelet knife length error
Eyelet knife length is too short to form the shape
in case of eyelet shape.
Re-input by
reset
Edit sewing data screen [S017]
number of times of (OFF/blasting)
(during continuous sewing)
Standard screen
E487
Eyelet shape error
Eyelet shape length is too short to form the shape
in case of eyelet shape.
Re-input by
reset
(During individual sewing/cycle
sewing)
Sewing data edit screen
[S014] Eyelet shape length
(during continuous sewing)
Standard screen
E488
Taper bar-tacking compensation error
When bar-tacking length is too short to form the
shape in case of taper bar-tacking shape
。
Re-input by
reset
(During individual sewing/cycle
sewing)
Sewing data edit screen
[S008] 2
nd
bar-tacking length
(during continuous sewing)
Standard screen
E489
Knife size error (at the time of plural motions
of knife)
When knife size is larger than cloth cutting knife
size.
Re-input by
reset
(During individual sewing/cycle
sewing)
Sewing data edit screen
[S002] Cloth cutting length
(during continuous sewing)
Standard screen
E492
Oversized basting presser
When stitching data of basting exceeds presser
size.
Re-input by
reset
(During individual sewing/cycle
sewing)
Sewing data edit screen
[S040] Basting needle entry
compensation
(during continuous sewing)
Standard screen
E493
Oversized bar-tacking presser at the sewing
end
When stitching data of tie stitching at sewing end
exceeds presser size.
Re-input by
reset
(During individual sewing/cycle
sewing)
Sewing data edit screen
[S067] Bar-tacking width at the end
of sewing
(during continuous sewing)
Standard screen
E494
Oversized bar-tacking presser at the start
starting
When stitching data of tie stitching at sewing start
exceeds presser size.
Re-input by
reset
(During individual sewing/cycle
sewing)
Sewing data edit screen
[S064]Bar-tacking width at the start
of sewing
(during continuous sewing)
Standard screen
E495
Presser size error (Width direction: right only)
When stitching data exceeds the size of right only
of width direction of presser.
Re-input by
reset
(During individual sewing/cycle
sewing)
Sewing data edit screen
[S003]Right knife groove width or
[S006] ratio of right and left shapes
(during continuous sewing)
Standard screen
E496
Presser size error (width direction: left only)
When stitching data exceeds the size of left only
of width direction of presser.
Re-input by
reset
(During individual sewing/cycle
sewing)
Sewing data edit screen
[S004]Left knife groove width or
[S006] ratio of right and left shapes
(during continuous sewing)
Standard screen
E497
Presser size error (length direction: front)
When stitching data exceeds the size of front of
length direction of presser.
Re-input by
reset
Standard screen