88
GENERAL CARE AND MAINTENANCE
PUTTING FORKLIFT IN STORAGE (cont’d)
PRE-STORAGE SERvICING
1. Lubricate the forklift (refer to page 85). Change the oil and coat
all exposed areas of hydraulic cylinders with corrosion resistant
grease.
2. Charge the battery and leave it disconnected from the forklift.
Store the forklift in a low re-risk area.
SERvICING THE FORKLIFT IN STORAGE
1. Periodically check the specic gravity and level the battery uid.
Charge and replenish as necessary. Perform uniform charge on the
battery every 2 months.
2. Check various sections of the forklift for stains or corrosion. Clean
such areas and coat with a corrosion preventive agent.
POST-STORAGE SERvICING
3. Wipe anticorrosive grease off the outer parts of the oil pressure
cylinder.
4. Lubricate each part.
5. Check the battery uid level and specic gravity. Fully charge the
battery.
6. Turn the ignition switch "ON" and check the meters, warning lights
and indicators.
7. Perform Daily Inspection (refer to page 72).
To Next Page
Loading...
