administration.fm
A31003-C1000-M101-1-76A9, 03/2016
OpenScape Desk Phone CP200/400/600, Administrator Documentation
127
Administration
Feature Configuration
3.8.4 Group Pickup
3.8.4.1 Feature Code
This feature allows a user to answer a call from any alerting phone that is in the same pickup
group. Prerequisites: The phone has to be assigned to a pickup group on OpenScape Voice
and the corresponding URI of the Call Pickup group service provided by the server is config-
ured on the phone. An example pickup URI is "**3". See Section 3.8.4.2, “Pickup alert” for op-
tions on visual and audible indication.
Administration via WBM
System > Features > Addressing
3.8.4.2 Pickup alert
If desired, an incoming call for the pickup group can be indicated acoustically and visually if
Group pickup visual alert is configured.
The Group pickup tone allowed parameter activates or deactivates the generation of an
acoustic signal for incoming pickup group calls. The default is "Yes". If this is activated, Group
pickup as ringer determines whether the current ring tone or an alert beep is used. If set to
"Yes", a pickup group call will be signaled by a short ring tone; the currently selected rigtone is
used. If set to "No", a pickup group call will be signaled by an alert tone. The default is "Yes".
>
This feature is only available when allowed under System > Features > Feature ac-
cess (see Section 3.7, “Feature access”).
>
The BLF pickup code parameter is only relevant when the phone is connected to an
Asterisk server.
Conference
Group pickup URI
Callback: FAC
BLF pickup code
*0
Addressing
MW server URI
192.168.1.2
Submit
Reset
Callback cancel all
To Next Page
Loading...
