Unify CP200 - SNTP Is Available, but no Automatic Configuration by DHCP Server

administration.fm
A31003-C1000-M101-1-76A9, 03/2016
OpenScape Desk Phone CP200/400/600, Administrator Documentation
95
Administration
System Settings
3.6.5.1 SNTP is Available, but no Automatic Configuration by DHCP Server
Data required
• SNTP IP address: IP address or hostname of the SNTP server.
• Timezone offset (hours): Shift in hours corresponding to UTC.
• Daylight saving: Enables or disables daylight saving time in conjunction with Auto time
change.
Value range: "Yes", "No".
• Difference (minutes): Time difference when daylight saving time is in effect.
• Auto time change / Auto DST: Enables or disables automatic control of daylight saving
time according to the DST zone.
Value range: "Yes", "No". Default setting is Yes. After a factory reset, the system will be re-
set to this value.
• Time zone/DST zone: Area with common start and end date for daylight saving time.
Value range: "Australia 2007 (ACT, South Australia, Tasmania, Victoria)", "Australia 2007
(New South Wales)", "Australia (Western Australia)", "Australia 2008+ (ACT, New South
Wales, South Australia, Tasmania, Victoria)", "Brazil", "Canada", "Canada (Newfound-
land)", "Europe (Portugal, United Kingdom)", "Europe (Finland)", "Europe (Rest)", "Mexi-
co", "United States", "New Zealand", "New Zealand (Chatham)".
Default setting for US is "United States". After a factory reset, the system will be reset to
this value.
Administration via WBM
Date and Time
>
Please note that Difference (minutes) must be specified both for manual and auto-
matic DST toggling.
SNTP IP address
Timezone offset (hours)
Date and time
Daylight saving
Time source
192.43.244.18
Daylight saving
Difference (minutes)
Auto time change
;
DST zone
Europe (Rest)
Submit
Reset
1
60