Unify CP200 - Settings for a DSS Key

administration.fm
A31003-C1000-M101-1-76A9, 03/2016
OpenScape Desk Phone CP200/400/600, Administrator Documentation
183
Administration
Multiline Appearance/Keyset
Administration via WBM
System > Features > DSS Settings
Administration via Local Phone
3.11.6.2 Settings for a DSS key
The Key label <n> parameter provides the DSS key with a label that is displayed on the graph-
ic display on an OpenScape Desk Phone CP phones. The label is also user configurable.
Address contains the call number of the line associated with the DSS key.
The Realm parameter stores the SIP Realm of the line associated with the DSS key.
User Identifier gives the SIP user ID of the line associated with the DSS key.
Password provides the password corresponding to the SIP user ID.
The Outgoing calls parameter determines the behaviour of a call over the DSS line at the tar-
get phone. If set to "Direct", any forwarding and Do not Disturb settings on the target phone will
be overridden, so that a call will always alert. If set to Line type is set to "Normal", this is not the
case, and the call will be treated like a regular call.
|
--- Admin
|
--- System
|
--- Features
|
--- DSS operation
|--- Deflect to DSS
|--- Refuse DSS pickup
|
--- Forwarding shown
|
--- Admin
|
--- System
|
--- Features
|
--- Configuration
|
--- General
|
--- DSS Pickup timer
Call pickup detect timer (seconds)
Deflect alerting call enabled
Allow pickup to be refused
DSS settings
Submit
Reset
3
Forwarding shown