Unify CP200 - Page 198

Administration
A31003-C1000-M101-1-76A9, 03/2016
198 OpenScape Desk Phone CP200/400/600, Administrator Documentation
administration.fm
Ringer Setting
The relevant information is carried as a string in the SIP Alert-Info header. This string is config-
ured in the OpenScape Voice system; please refer to the relevant OpenScape Voice documen-
tation. When the string sent via alert-info matches the string specified in the Name parameter,
the corresponding ringer is triggered. For instance, the OpenScape Voice system may send the
string Bellcore-dr1 to indicate that a call is from within the same business group, and the
Name parameter is set to "Bellcore-dr1". To select a specific ring tone for calls from the same
business group, the other parameters corresponding to that Name must be set accordingly.
The Ringer sound parameter determines whether a pattern, i. e. melody, or a specific sound
file shall be used as ringer.
Pattern melody selects the melody pattern that will be used if Ringer sound is set to "Pattern".
Pattern sequence determines the length for the melody pattern, and the interval between the
repetitions of the pattern. There are 3 variants:
• "1": 1 sec ON, 4 sec OFF
• "2": 1 sec ON, 2 sec OFF
• "3": 0.7 sec ON, 0.7 sec OFF, 0.7 sec ON, 3 sec OFF
The Duration parameter determines how long the phone will ring on an incoming call. The
range is 0-300 sec.
With the Audible parameter, the ringer can be muted. In this case, an incoming call will be in-
dicated only visually.
Special Ringers can be configured for the following call types:
• Internal
• External
• Recall
• Emergency
• Special1
• Special2
• Special3
Abstract names used for Special Ringers:
•"Bellcore-dr1" - normal (internal) alerting or ring-back;
•"Bellcore-dr2" - external alerting or ring-back;
•"Bellcore-dr3" - recall alerting or ring-back (e.g., following transfer).
>
To make the special ringers available and configurable to the user, the administrator
needs to map the call types to specific ringers via the Ringer setting mapping table
in Admin > Ringer setting > Distinctive. Each call type can be mapped to a spe-
cific Ringer sound, Pattern Melody, and Pattern sequence.