Unify OpenScape 4000 User Guide Hfa

Other settings and functions 175
Speaker call to a target destination
Prerequisite: The system code for “Voice call group participants“ and the speed
dial number for the corresponding group member are programmed on a desti-
nation dial key  page 107.
Press the programmed dial key. It will immediately establish a connection with
the destination’s loudspeaker.
^ The receiver can establish the connection by picking up the handset.
: When the receiver the loudspeaker key
or
presses the line key (if set-up), the connection is cancelled.
Speaker call to a variable target
When talking in a group, the loudspeaker and microphone on the target phone
are automatically turned on.
^ Lift the handset.
or
: Press the key to use speakerphone mode.
j System code for “Speaker call“ (ask relevant administrator if necessary)
or
Press the “Speaker call“ key, if it is set up.
j Enter the speed dial code for the corresponding group member.
Loudspeaker and microphone of the target phone are automatically turned on.
Speaker call to a target destination
Prerequisite: The system code for “Speaker call“ and the speed dial number for
the corresponding group member are programmed on a destination dial key
 page 107.
Press the programmed key.
Loudspeaker and microphone of the target phone are automatically turned on.
123456
_
Line 1
_
Speaker call
_
DSS
_

Unify OpenScape 4000 Specifications

General

Brand	Unify
Model	OpenScape 4000
Category	Telephone
Language	English