UniPOS IFS7002 two signal loops
Instruction Manual Page 80
Revision 11/01.17 Of 145
13.5.1.3. Menu Remove address
The menu allows the user to
remove particular devices from the
zone:
For each device is displayed:
Its number in the zone, the
loop it is included in, and the
address in the loop – in the
top line
The text message – in the
line beneath.
The devices in a zone are
numbered according to the following
sequence:
Devices in Loop 1
obtain numbers
increasing along with
the addresses;
Devices in Loop 2 obtain numbers increasing along with the addresses.
The selected device is pointed by arrow – „>>”.
Buttons and in the right panel section are visualized if more than one device is available;
the Go to field and the digit buttons appear if more than 7 devices are available in the zone.
Press a digit button and the Go to field is activated; you can enter a random 2-digit number for a
device in the zone. To edit the number, use button , press the button to delete the last inserted
digit.
When you press button and a number is already entered in the Go to field, the devices
whose number is in the field will be selected:
If the number is 0, the first device in the zone will be selcted;
If the number is higher than the catual number of devices in the zone, the last device will be
selected.
Simultaneously, the number in the Go to field will be deleted, i.e. the field is deactivated.
When you press button after a number is enterd in the Go to field, the field itself is
deactivated.
When you press button and the Go to field is empty, the devices will be removed from the
zone. When the last device is removed from the zone a screen with the text message Free zone
appears; the only option is to exit the menu.
Mode: DAY LOC 13:41:53 Wed 24 Mar 2010
SetUp Zone 1 Remove address Go to:
Total: 17
>> 1 Lp1 Аddr1
Point 1.001
2 Lp1 Аddr2
Point 1.002
3 Lo1 Аddr3
Point 1.003
4 Lp1 Аddr4
Point 1.004
5 Lp1 Аddr10
Point 1.010
6 Lp1 Аddr11
Point 1.011
7 Lp2 Аddr1
Point 2.001
To Next Page
Loading...
Need help?
General
