Uponor Smatrix Base PULSE User Manual

Connect communication cable to thermostat
SI0000036
A B + -
1
2
3
1. Insert the four wires into the removable connectors marked (A,B,
+ and -) on the thermostat.
2. Tighten the screws fixing the wires in the connector.
3. Insert the connectors on the input pegs on the thermostat.
Attach thermostat to the wall
CD0000004
The thermostat is delivered in a kit with screws, wall plugs, and a wall
bracket, presenting several options of attaching the thermostat to the
wall.
Wall bracket (recommended)
60 mm
1
2
3
SI0000026
Attach the thermostat to the wall using the wall bracket, screws and
wall plugs.
Screw and wall plug
5
1
2
3
4
SI0000025
Attach the thermostat to the wall using the screw and wall plug.
Register thermostat to room controller
1. Enter registration mode
3 s
SI0000065
Press and hold the OK button on the room controller until the LED for
channel 1 (or the first unregistered channel) flashes red.
2. Select a channel
SI0000068
1 65432
Use buttons < or > to move the pointer (LED flashes red) to a
preferred channel.
3. Lock selected channel
SI0000071
Note
It is recommended to register all channels to the
thermostat at the same time.
Press the OK button to select the channel for registration. The LED
for the selected channel starts flashing green.
Select all channels to be registered to the thermostat and continue to
the next step.
Uponor Smatrix Base PULSE
|
Installation and operation manual
|
43

Uponor Smatrix Base PULSE Specifications

General

Brand	Uponor
Model	Smatrix Base PULSE
Category	Controller
Language	English